height的例句大全

Culvert inlet passage has the characteristics of low channel height, small foundation excavation depth, simple structure, a single cross sectional shape changes, ease of construction and other features, so more and more attention has been paying on this pumping station project.

箱涵式进水流道具有流道高度低，基础开挖深度小；结构简单，断面形状变化单一，易于施工等特点，在泵站工程中得到越来越多的重视。

From 2003 to 2005, the cumulative yield was up to about 7.457 4 billion for the seeds with average shell height of about 2 mm and 4.984 2 billion for those after juvenile nursery culture with 66.84% survival rate.

2003￣2005年累计培育平均壳高2mm的稚贝74.574亿粒，经中间培育后出池商品仔贝49.842亿粒，中间培育成活率达到66.84%。

Most of the teeth harvested from the Shh antibody group were small and abnormal. A single irregularly shaped cusp was visible, and a partial crown formed. The main cusp height in this group was significantly lower than that in the Shh-N group.

Shh抗体阻断组形成的牙宽度较小，牙冠形态不规则，只有一个明显的牙尖且牙尖高度较Shh-N体外诱导组和对照组明显变低。

Assessment of critical stable height of vertical cut slopes of unsaturated soils considering drying shrinkage cracks on ground

考虑干燥裂缝时非饱和土垂直切坡临界自稳高度

Based on the two variables of stress state, formulas for estimating the critical stable height of vertical cut slopes of unsaturated soils are established respectively for two cases in which suction is constant or linearly decreases with depth.

利用双应力状态变量表示方法，建立了考虑干燥裂缝时吸力沿深度均匀分布和随深度线性减小两种情况下垂直切坡极限自稳高度表达式。

The Configuration Method and Practice on the Height Control System of Flame Cutter

火焰切割机高度控制系统配置方法与实践

Design of DC Motor Control System in NC Flame Cutter Height Automatic Adjustment Device

数控火焰切割机自动调高器中直流电机控制系统设计

The height control system is an important component of numerical control flame cutter which is an important processing machine in manufacturing industry.

数控切火焰割机是加工制造业的重要加工机械，而高度控制系统是其重要的组成部分。

Capacitance Automatic Height-Adjusting System for Single Cutting Torch of the Cutting Machine

切割机单割炬电容自动调高控制系统

Torch height controller is used to adjust the distance between steel plate and cutting nozzle, in order to assure cutting quality and prolong the using of the cutting nozzle.

无论是火焰还是等离子切割，都必须保证割嘴离钢板的高度处于最佳的状态，从而得到最佳的切割效果和最长的割嘴使用寿命。

The areal distribution of the cyclonic circulation with height of the experimental storms has also been measured, also agreeing quite well with the observed ones.

还测量了各层气旋性环流所占面积随高度的分布，与实况也相似。

It is found that the buckling strength of column-supported silos is mainly dependent on the height of the engaged column, which also affects the buckling deformation mode.

结果表明，支柱伸入高度是影响仓壁柱承钢筒仓轴压下屈曲强度的主要因素，屈曲模态也与之密切相关；

The lift height, the distribution ratio of liquid flow, the liquid conveying rate and the efficiency increased with the increase of the discharge pressure.

当抽吸压力不变时，随压冲压力的增大，涡流二极管泵的扬程、流量分配比、输送量及装置效率都随之增加。

The paper briefly introduces absolute calibration methods of sea surface height and backscatter of satellite altimeter.

介绍了卫星高度计定标中海面高度和后向散射系数的定标方法。

Some types of probability distributions previously used for estimating wave height in return period are reviewed in this aper.

本文对以前使用的推算重现期波高的几种概率分布进行了评述。

A new method of return period wave height calculation

推算波浪多年一遇波高的新方法

The calibration system of sensor is designed and realized. Sensors in the unmanned aerial vehicle system such as attitude angle sensor, barometric height sensor and airspeed sensor are calibrated times without number. Each of their stationary models is deduced.

设计实现了传感器标定建模，以无人机系统中倾角传感器、气压高度传感器和空速传感器等为例，进行了传感器数据的标定拟和，得到了各传感器的静态模型。

Microadding a appropriate amount of rare-earths oxide can decrease leakage current by means of raising the height of barrier potential and increasing grain resistivity of zinc oxide.

添加微量稀土氧化物通过增大势垒高度和氧化锌晶粒电阻率来减小泄漏电流。

By changing the thickness of organic and inorganic layers or adjusting the relative height of barrier potential at organic-inorganic interface, we can control the emission zone and obtain different emission from each layer.

对所制备的3种结构器件的EL进行了比较，研究了结构对发光起因的影响，揭示通过调节有机层和无机层厚度以及界面势垒高度可以实现对发光区域的控制。

Vary temperature, barrier height, and potential energies.

不同的温度、势垒高度和潜能。