joint的例句大全

The Study of Stress Concentration Coefficient of Cruciform joint Based on ANSYS

基于ANSYS的十字接头焊应力集中系数研究

Structural behaviors of the connections between concrete filled square tubular column and steel beam have been studied by the tensile tests of cruciform joint models with inner diaphragm.

本文通过对带内隔板的十字形连接节点的拉伸试验，研究了方钢管混凝土柱与钢梁连接的结构性能。

CT Image Processing and Cubic Structure Analysis of Hip Joint

CT图象处理与髋关节立体结构分析

The Study of Cubic Structure of Hip Joint Based on CT Volume Datasets

基于CT三维数据的髋关节立体结构研究

The facet joint morphology of lumbar lateral curvature and clinical significance

腰椎侧弯患者关节突关节形态及其临床意义

With a sharp knife cut down into the joint between the thigh and the breast.

用一把锋利的刀子切开大腿和鸡胸结合的部位。

The joint specimens were exposed, fixed, decalcified, wrapped and cut into slices.

再经固定、脱钙、包埋，制成切片。

Through analysis of performance test for high temperature bolts on joint face of the steam cylinder, it is believed that the main factors affecting the safe application performance of high temperature bolts are undue and nonhomogeneous pretightening loads.

通过对汽缸结合面高温螺栓的性能试验分析，认为预紧力过大和预紧力不均匀是影响高温螺栓安全使用性能的主要因素。

Service life loss of high temperature bolts on joint face of the steam cylinder and analysis for safe application performance thereof

汽缸结合面高温螺栓寿命损耗及其安全使用性能分析

Imaging diagnosis of adjacent joint bone cyst ( analysis of 12 cases)

邻关节囊肿的影像学诊断（附12例报告）

The results show that aggregating effect increases with a larger proportion of additional ordering cost to ordering cost, and the joint ordering policy approaches to the optimal one;

算例结果表明：当附加订购成本占订购成本的比例较大时，集聚效应明显，最优的订购策略趋于联合订购；

In the face of political pressure, Carlyle first reduced its intended investment from 85 per cent to a 50-50 joint venture.

面对政治上的压力，凯雷先是缩减了计划投资规模，从收购85%的股份，改为组建一家对等持股的合资企业。

Bend formed steel plate lifting shackle Analysis and Calculation of Crank's Optimum Section Shape in Three-Crank Universal Joint

钢板弯曲成形吊叉三叉杆滚子式万向联轴器叉杆修形的分析与计算

The tensile strength of the joint of pulse submerged arc welding is 50 MPa higher than that of ordinary submerged arc welding, which is about 12% higher. Under the same heat input, there is failed test piece in the ordinary submerged arc welding.

脉冲埋弧焊比普通埋弧焊在抗拉强度上增50MPa，大约12%左右，普通埋弧焊在与脉冲埋弧焊同样的热输入条件下出现了不合格试件。

The maximum horizontal tensile stress and the maximum transverse tensile stress both occurred at the repaired joint between the bottom of polyurethane facing concrete and the top of granular groundwork.

最大水平拉应力和最大横向拉应力均出现在修补后的聚氨酯混凝土面层与粒料基层交接面。

Mainly used to joint for conveying belt normal temperature materials.

主要用于输送常温材料的输送带接头。

In aspect of enterprise efficiency, state-owned commercial banks were behind the joint-stock commercial banks in terms of combined efficiency.

在企业效率方面，国有商业银行在综合效率方面明显落后于股份制商业银行。

Evaluation and Discussion of Root Flaw of Welded Joint with Backing Strip

射线底片上带垫板单面焊缝根部缺陷的识别探讨

Here, the torque load characteristics of the universal joint transmission shaft are analysed with the rotary tiller, combine and pickup baler in the condit-ions of field operation and starting.

本文分析了旋耕机、联合收割机与捡拾压捆机的万向节传动轴的扭矩载荷特点；

Repair Welding Joint Boundary Structure and Performance of Explosion Composite Plate

爆炸复合板补焊接头界面的微观组织与性能