shear的例句大全

Experimental study on seismic behavior of shear walls wih X-shaped concealed bracing and concealed vertical joint

带X形暗支撑设暗竖缝剪力墙抗震性能试验研究

The effect of semi-rigid base layer conditioning period, high penetration emulsified asphalt spread temperature and conditioning temperature to the penetration effect were also analyzed. Furthermore, the shear strength test between surface and base layers were utilized to obtain the optimal content of high penetration emulsified asphalt.

并分析了基层养生龄期、高渗透乳化沥青洒布温度、养生温度等因素对渗透效果的影响。其次，进行了基层与面层间抗剪强度试验，得到了高渗透乳化沥青最佳用量。

The new shear connector of the bend bar on the one hand meets the requirements for shearing and lifting resistance, and on the other hand saves the construction time, labor and materials, and is of great vistas of popularization.

波形弯筋连接件既能达到抗剪切、抗掀起要求，又能省时、省力、省材，具有极大的推广应用前景。

The mixing process mainly involves the three following microscopic mechanism: fast convective mixing, slow diffusive mixing, and local shear mixing.

研究发现，床内物料混合过程大致可归纳为快速对流混合、缓慢扩散混合、局部剪切混合三种微观机理。

The velocity distributing, variation of extension rate, shear rate and the natural convergence angle of the fluid were analyzed under different initial entry pressure.

分析了在不同口模压力（P）下入口区速度分布、延伸应变速率、剪切应变速率以及流体自然收敛角的变化。

It comes on with some mesoscale system, such as mesoscale convergence line wind shear, gale area and so on.

强对流天气在速度场上表现为中尺度辐合线、风向风速辐合区、风速辐合区、大风区等中尺度系统。

Results show, it is the principle influencing systems that the upper trough, surface convergence line, The low level southwest jet and shear line.

分析结果表明，高空南支槽、地面辐合线、850hPa西南急流和切变线，是这次强对流天气过程的主要影响系统；

The axes of low-layer helicity plus center is concurrent with shear line and the convergence line of surface inversion trough.

低层螺旋度大值中心轴线与切变线和地面倒槽辐合线走向一致，高层螺旋度与高空急流有关。

Shear Wall Foundation Design Considering Cooperative Effect

考虑共同作用高层结构剪力墙基础设计

Based on the Reissner Mindlin type global displacement field and predictor corrector method, the deflections and transverse shear stresses were investigated for laminated composite cylindrical shells under mechanical load.

本文根据Reissner Mindlin型的全局位移场（一阶和三阶），应用有限元预测&修正法，数值计算和分析了机械载荷作用下复合材料层合圆柱壳的挠度和横向剪应力。

This paper proposes using multiple correlation analysis to analyze shear wave velocity.

本文提出采用多重相关分析来分析剪切波速度。

EXPERIMENTAL STUDY ON TORSIONAL FATIGUE BEHAVIOR OF COUPLING BOLT FOR THE STEAM TURBINE Performance experiment for viscous shear damper

汽轮机联轴器螺栓剪切疲劳试验研究粘性剪切型阻尼器性能试验研究

Based on the experimental results, a method is proposed for calculating the shear-resistance capacity of the beam-column joints strengthened by composite cover of high strength wire cable mesh and polymer mortar, and the compute results agree well with the experimental results.

并且，在试验基础上提出了震损后采用钢绞线网-聚合物砂浆复合面层加固钢筋混凝土框架节点抗剪承载力的计算方法，计算结果与试验结果符合良好。

The main function of vibration crushed gravel is to squeeze soil, eliminate earthquake liquid and debase liquid grade, it also enhance the property of soil drainage, spread consolidation, improve compressibility and shear strengh.

振动挤密碎石桩在组合型复合地基中主要作用是对土体进行挤密，消除地震液化或降低液化，增加排水性能，加速土体固结，改善土的压缩性和抗剪强度。

The existing anchorage system for prestressed tendons and cables of steel is no longer appropriate for that of FRP due to their low transverse shear strength and crushing resistance.

但其横向抗剪及抗挤压强度较低，现有的预应力筋和拉索锚具体系不再适用于FRP预应力筋和拉索。

All these demonstrated that a close relationship existed between length of endothelial cell monolayer and protein metabolism of endothelial cells, indicating the existence of cumulative effect of tensile stress in the upper endothelial cell membrane under the shear flow field.

本试验结果表明在相同切应力条件下，单层内皮细胞长度与其蛋白质代谢有密切的相关，进而从一个侧面证明血管内皮细胞膜张应力存在累加效应。

The factors of influence on shear strength of heat curing silicone rubber/ aluminum alloy were studied.

研究了影响热硫化硅橡胶与合金铝粘合剪切强度的几个因素。

A New Method for Calculation Shear Plane Area in Oblique Cutting with Double Edge

新的斜角非自由切削剪切面积计算方法

The paper proposes a new method for calculating shear plane area based upon a new oblique cutting model with double edge.

根据新的斜角非自由切削模型，本文提出了新的剪切面积计算方法。

The Failure Stress Condition on the Maximum Cyclic Shear Surface Associated with the Failure Stain Criterion of Flyash

粉煤灰最大往返剪切作用面上应变破坏标准的应力条件