simulation的例句大全

Simulation experiments on the compensation of cotton population to the decrease of plant number caused by black cutworm

小地老虎为害棉苗缺株产量损失及棉株群体补偿力模拟试验

Artificial low temperature freezer simulation. In cold environment, a lowtemperature environment of cyanide poisoning animal model.

实验方法：1.以人工低温冰柜模拟寒冷环境，建立低温环境氰中毒动物模型。

Target vehicle models before and after optimized for dynamic simulation were established. Angle gradients of steering, roll and pitch were analyzed in vehicle stability simulations, so were the maximum lateral accelerations.

建立了目标车优化前、后的动力学整车仿真模型，分析了两者在整车性能仿真试验中的方向盘转角梯度、侧倾梯度、最大侧向加速度和制动俯仰角梯度等性能。

Simulation of the cyclic voltammetry of surface modified electrodes

表面修饰电极循环伏安过程的模拟计算

Analysis and Simulation of Flow Characteristics of Cycloidal Pump

摆线泵流量特性分析及计算机仿真

Simulation analysis and structural optimization for a liquid-liquid hydraulic cyclone

液-液水力旋流器的模拟分析与结构优化

Through field experiments and numerical simulation to prove the feasibility of using Fluent computational fluid dynamics software to simulate the internal flow field of the cyclone filter streaming filter.

通过田间试验与数值模拟进行比较，证明了利用Fluent流体力学计算软件对旋流式过滤器内部流场进行模拟的可行性。

On the basis of determining numerical simulation method of cyclone filter, the flow fields of the cyclones are numerically simulated respectively by use of professional computational fluid dynamics software FLUENT.

在确定了旋风过滤器数值模拟方法的基础上，利用FLUENT计算流体动力学专业软件对所设计的两种旋风过滤器分别进行了单管和多管流场的数值模拟。

Non-linear Numerical Simulation for an Electron Cyclotron Maser with Complex Focusing-Fields

复合场电子回旋脉塞非线性计算机辅助分析

Numerical simulation on characteristics of emergency shut-down of cylindrical valve for hydraulic turbine

水轮机筒阀动水关闭特性的数值模拟

Multi-Objective and Varying Parameter Optimization of Machining Parameters Based on NC Simulation Data

基于仿真数据的数控铣削加工多目标变参数优化

The result indicates that the model can simulate the varying duty working characteristics of nuclear steam turbine plant accurately, and meets the needs of simulation analysis work on secondary system of nuclear power plant.

结果表明，该模型能准确模拟核汽轮机装置的变负荷运行特性，满足核动力二回路系统实时仿真分析要求。

Walsh function approach to optimal control and Simulation of linear time-varying system

用WALSH函数实现线性时变系统的最优控制和仿真

A concurrent permutation based multilevel matrix ordering strategy for parallel process simulation

针对复杂系统并行模拟问题的并发式多级矩阵重排算法

Simulation of Ordered Domain Interfaces Formed between DO_ ( 22) Phases in Ni-Al-V Alloy Using Microscopic Phase-Field Model

Ni-Al-V合金DO（22）相间有序畴界面的微观相场模拟

Application of Monte-Carlo Method for Heat Transfer Simulation in The Opposed Firing Boiler

蒙特卡洛法在对冲燃烧锅炉传热计算中的应用

Numerical off-line simulation is carried out at different starting up conditions ( engine engaging speed, load torque and clutch LQR control parameters). The results are investigated and analyzed.

在不同的起步条件下（发动机起步转速、负载以及离合器LQR控制参数）对该模型进行了离线仿真分析，并与闭环控制策略的起步性能进行比较。

Basing on Archard wear model, the rule of die wear is studied by simulation, and the relation between wearing depth and the times of die service is found by means of unitary linearly regression, then the service life of die is previewed.

基于Archard磨损模型，对直齿轮温挤压模具的磨损规律进行分析，并利用一元线性回归法，找出模具表面磨损深度与服役次数之间的关系，以磨损值为判据，预测模具的使用寿命。

Numerical simulation of gas flow field in wearing resistance valves

耐磨风量调节阀气相流场的数值模拟

Finally, we compare six degrees of freedom simulation results of ballistic re-entry missiles motion with the computing results of approximate formula. The comparison shows the feasibility of the approximate analysis.

最后用六自由度弹道数字仿真结果同近似计算结果作了比较，比较结果表明了近似分析的可行性。