tension的例句大全

Experiment of equal biaxial tension for stress-strain relationship of rubber

橡胶等双轴拉伸实验介绍

Study on the biaxial tension test of fabric material

薄膜材料双轴拉伸试验

Performance of Upgraded 1332 Winding Frame ANALYSIS OF WINDING TENSION OF WARP BEAMING OF SECTIONAL WARPER

国产1332型络筒机的技术改造大圆框分条整经机上轴张力分析

The results show that according to the curve of time varying interface acceleration, the process of DME bubble gorwth can be divided into three domains: surface tension controlled growth, transition domain and heat transfer controlled growth.

研究结果表明，根据气泡生长的加速度曲线，二甲醚气泡的生长过程可划分为表面张力控制阶段、过渡阶段和传热控制阶段。

Methods: The contractile force of the isolated left atria was determined by tension recording method.

方法：采用张力描记法测定离体豚鼠左房肌的收缩力。

The Level-Set approach was adopted to deal with some factors such as deposited track, liquid/ vapor interface, which considered surface tension gradient ( the major driving forces for the melt flow), interface curvatures, buoyancy and convection heat loss.

通过水平集（level set）方法处理熔积轨迹、液/气界面等因素，考虑了熔体流动的主要驱动力表面张力梯度、表面曲率以及浮力等。

In particular, just like elastic strings, the field lines exert tension forces when they are bent or curved. a tightly stretched cord of wire or gut, which makes sound when plucked, struck, or bowed.

特别是当磁力线被弄弯或扭曲时，就像有弹性的弦，会施展张力。一种当拨弄、弹击或弯曲时发出声响的金属线或肠线。

The model of the aluminum alloy wheel classified as 16 x 6.57 is built. Static stress analysis is carried out to study the influence of bolt pre-tension, centrifugal force and the cornering force to the structural as well as the distributing rule of stress and strain.

首先根据试验工况建立起16×6.5J车轮的有限元模型，通过静力分析研究螺栓预紧力、旋转离心力和试验弯矩对车轮结构强度的影响以及车轮结构的应力应变分布规律。

The factors that affects the coverage for core are core coverage, tension, gauge, pipe socket, traveler and the position of the core yam for feeding.

影响包芯纱包覆性能的因素主要有：皮/芯比例、包覆量、芯纱张力、两根棉粗纱间隔距、喇叭口、钢丝圈大小、芯纱喂入位置等。

Using commercially available crimping pliers, press the eyelet together with the tension cable in two places.

用商用卷边钳子，在两处同时按压孔眼和张紧拉线。

The fatigue life-spans of specimens after dehydrogenization heat treatment and crystallization heat treatment are all decreased observably, which is caused by the tension internal stress.

经过除氢热处理和晶化热处理的试样的疲劳寿命，与基底试样和镀态试样相比都显著降低，而热处理后试样疲劳强度的降低是由于镀层的内应力引起的。

This paper analyses and concludes the CDCM manufacturing techniques of cold rolling factory, composition and information exchanging of loop electricity cybernetic system, parameter calculating and setting, control method of loop, operation state and precision of tension controlling.

结合实际，对冷轧厂CDCM生产线的工艺过程、活套电控系统组成及信息交换、参数的计算与设定、活套控制方式、运行状态及张力控制精度等进行分析和总结。

Study on Cyclic Stress Strain Relation Under Tension Torsion Complex Loading

拉扭复合加载下循环应力应变关系的研究

All patients underwent low tension double contrast barium enema.

所有病例均行低张双对比灌肠造影。

The pressure of having to take a test causes a lot of tension.

要考试的压力带来了很大的紧张。

The distribution law of corona current and electric field strength in high tension separator

高压电选机内电晕电流和电场的分布规律

The compress strength of basaltic rock mass increases by 2~ 3 times from upper part, lower part of weakly weathered rock mass to fresh one, While tension strength increases with 1 magnitude.

从弱风化上段、弱风化下段到微新岩体，抗压强度以2～3倍的量级增大；而抗拉强度以一个数量级增大。

Schmid value of basal plane increased when sheet was under tension or compression deformation. Therefore, basal slip system became easier to start.

板材在拉压变形时基面Schmid因子增大，基面滑移系在常温下更容易启动。

An Experimental Study of Superplastic Yield Criteria under Tension-torsional Combined Loading

超塑变形屈服准则的拉扭复合实验研究

The critical micelle concentration ( CMC) of surfactant in low-temperature dyeing assistant CWL was measured with the method of surface tension.

用表面张力法测试了自制低温染色助剂CWL中表面活性剂的临界胶束质量浓度（CMC）。