test的例句大全

Results The rate of the test of tuberculosis bacteria turning to negative is up to 80.35% and the closing rate of the cavity is up to 37.14%.

结果耐药肺结核，痰菌阴转率高达78.36%，空洞闭合率达37.14%。

There are five PCBs which need test: CPU board, source board, stepmotor driving board and controlling board.

其中需要被测的电路板有5块，它们是CPU板、I/O板、电源板、步进电机驱动板及待测控制板等。

The Test Installment of Vulve Open and Close Dynamic Turning Moment of Force and the Intellectual Serial Communication of PC

阀门启闭动态转矩检测装置与PC机的智能串行通信

This let me test a prototype headstock design for a wood turning lathe I'd like to design and build.

这让我测试的车床我想设计和建造木材启闭原型设计。

Research on the Intelligent Turning Force Test System

智能化车削力测试系统研究

Development and Field Test of a Guidance System of CO_2 Laser Transmission Coded Order

CO2激光传输指令制导装置与外场试验

Test blast furnace casing temperature using fast infra-red temperature detector

应用快速红外测温仪检测高炉炉壳温度

Experiential Relationship between Indexes of Dynamic Sounding Test and Bearing Capacity for Crushed Stone Fill Dynamic Consolidation Foundation

碎石填土强夯地基动探指标与承载力的经验关系

Application of Heavy Dynamic Sounding Test in Granite Area in Guangdong

重型动力触探试验在广东花岗岩地区的应用

Application of Light Conic Dynamic Sounding Test in Construction Project

轻型圆锥动力触探试验在工程实践中的应用

The article discusses the cause of deformation in the hydraulic test of pressure tubing and suggests some solutions on the basis of analysis.

阐述了耐压管水压试验变形的根本原因，在分析的基础上，指出了解决问题的方法。

Deformation Study on Hydraulic Test of Pressure Tubing

耐压管水压试验变形研究

Hydraulic test for tubing is important during tubing repairing and quality assurance.

对油管进行水压试验是油管修复工艺流程必不可少的质量检测环节。

A noise control in static hydraulic test for tubing

油井管静水压试验系统的噪声控制

As a supporting test, valuation analysis for greenfield and acquisition scenarios is also conducted and the results support the statistical findings.

此外，作为补充分析，本文也对自行设立和兼并收购两种情况进行了估值比较分析，分析结果与统计结论保持一致。

The model is evaluated by comparing simulation results to Stirling engine test data, which were obtained from a four cylinder double acting Stirling engine.

结合某型4缸双作用斯特林发动机，开展了发动机的仿真研究和试验研究，研究结果表明，仿真计算的结果与实测值是基本吻合的，从而验证了本文所建立的非线性模型的有效性。

The test system of the electric braking is designed in the paper.

为了解决这个问题，本论文设计了飞机全电刹车测试系统。

The second part was the braking distance test system.

第二部分，制动距离检测系统设计。

The test shows that no surface blowhole formed when the amount of gas evolution was less than 5ml/ g.

试验表明，只要涂料发气量小于5ml/g，铸管不会产生表面气孔。

The Development of the Bluff Body Flowmeter with the Torque Test

双涡体扭矩检出式涡街流量传感器的研制