thesis的例句大全

The control of contactor with a new type of permanent magnet actuator is studied in this thesis.

执行器是楼宇自动化系统的重要组成部分，它的功能与性能直接影响控制的效果。

This thesis studies the problems of geometric continuity about surfaces reconstruction in Reverse Engineering.

本文研究反向工程中曲面重构的几何连续性问题。

Neuron adaptive controller with time lag system is mainly researched in the thesis.

本文主要研究了时滞系统的神经元自适应控制器。

In this thesis, we propose a new method to generate a focused hollow laser beam by using an azimuthally-distributed 2 π-phase plate and a convergent thin lens.

本文提出了采用2π位相板法产生聚焦中空光束的新方法。

Based on the damage mitigating control ( DMC), this thesis focuses on the damage analysis and control of the coolant channel ligament which is treated as one of critical components for the liquid-propellant rocket engines ( LRE) during a transiting operating condition.

针对减损控制技术，本文以液体火箭发动机为研究对象，视推力室冷却夹套隔片为易损部件，在发动机的转工况过程中，对其损伤进行分析与控制研究。

The thesis puts forward the study of bus relaying system based on multi-agent technology. The relaying system consists of coordination agent and execution agent.

第五章介绍基于多Agent技术的母线保护系统的研究。

After above analytical theories, we combine the two part of work into an integrated model of coronal heating. In this thesis, we investigate the role of Alfven wave in the coronal heating process.

在完成了本论文的理论工作后，我们将这两个部分的理论结合起来，就得到了一个相对完整的日冕加热模型，包含了Alfven波的波源和耗散机制。

The thesis mainly discussed the question, assumed conditions, models, objective function, constraints of single airport ground-holding model and single airport and air corridor ground-holding model.

论文主要研究了单机场地面等待模型和综合考虑机场和走廊口两部分空域的地面等待模型的问题提出，假设条件，模型建立，目标函数，约束方程等。

In this thesis, the calculation method of the elastic force and strength of varied section open-ring has been proVided, If this kind seating ring of supporting ring is used in cylinder case, the uniform elastie force ex-erted on cylinder wall by the ring is produced.

本文主要论证了变截面开口圆环的弹力集度及强度校核计算方法，缸套内采用这种密封环或支承环，可使圆环对缸壁沿圆周产生均匀的弹力。

In this thesis, it studied the semiconductor laser pulse ranging system receiver circuit in depth.

本论文深入研究了半导体激光脉冲测距接收系统电路。

According to actual needs, the thesis identifies specific parameters of code system and select JPL rapid capture based on m-m composite sequences as ranging code signals of the system.

根据实际需要论证了码制的具体参数，选择了基于m-m复合序列生成的JPL快捕码作为系统的测距码信号。

Thesis analyses deeply the above mentioned four sources and their characteristics respectively from the aspects of cost distribution, human egoism, scientific and technological alienation and the accelerating role of politics for the use of disaster causing technology.

主要从市场的成本分摊性、人类中心论、科技异化以及政治对致毁性技术应用的加速作用分别对上述四种根源及特征进行了深入分析。

Then it proposes the model used in this thesis under the consideration of fixed cost distribution.

进而在考虑分摊固定成本的基础上，提出了本文所采用的选址模型。

The conclusions of this thesis can contribute to the design and construction of the offshore structures and the safety of the costal line as theoretical guidance.

本文研究成果对我国近海海岸安全，海洋结构物建设与设计以及其安全性，提供了理论指导。

During the computation of dike burst, this thesis used the formula of the broad-crested weir without bank to fulfill it.

在进行溃口计算过程中，本文采用无坎宽顶堰流公式来进行计算；

The thesis analysis is made on the crimp property of polyester/ modified high shrinkage polyester conjugated fiber. The crimp property of three kinds of conjugated fiber in different conditions such as heat processing ways, temperature and time is tested.

对聚酯/改性高收缩聚酯复合纤维的卷曲性能进行了理论分析，并测试了不同组分比例以及不同热处理方式、温度、时间条件下的聚酯/改性高收缩聚酯复合纤维的卷曲性能。

On the basis of it, this thesis sets up three sets of different types of pneumatic cushioning systems and successfully realizes their high-speed pneumatic cushioning control.

在此基础上，本文成功完成三套计算机控制智能高速气动缓冲系统的研制工作，并实现了系统的高速气动缓冲控制。

This thesis deeply researches on the task-computer control smart high-speed pneumatic cushioning system. which mainly includes the design of mechanical structure/ electronical circuit/ pneumatic loop and the researches of system modeling/ simulation/ control strategy.

本文对计算机控制智能高速气动缓冲系统进行了机械、电气、气路系统的设计以及系统建模方法、系统辨识研究和控制策略研究。

This thesis introduces the test and demonstration of checking method of ethanol, methyl cyanide and dichloride methane which are forbidden.

本文确定了药物合成过程中经常使用的有机溶剂（乙醇、乙腈、二氯甲烷）残留量的检测方法。

The thesis has established a special angle of view when analyzing the streaming structure and process of higher education with the idea of educational equity through the application of the method of organization theory.

运用组织理论的分析方法，确立了用教育公平观念来分析高等教育分流结构与分流过程的独特视角。