拧的例句大全

Gunnplexer tuning screw travels IN to LOWER the frequency.

耿儿的调谐螺丝往里拧频率降低.

Turn the screw to the right to tighten it.

向右转动螺钉把它拧紧.

He is always at cross-purposes with others.

他总是跟大家拧着.

Even the awful presence of Death struck no solemn chill upon him.

就是阎罗王狰拧面目,他见了都不会浑身发抖的.

The utmost drawing strength of direct assembling bolt in particleboard, medium density fiberboard and bamboo glue-laminated panel is about 23.1%, 39.1% and 36.3% bigger than that of nylon inbuilt nut respectively.

直接拧入式螺杆的极限抗拔力比尼龙预埋螺母的极限抗拔力高，刨花板、中密度纤维板、竹集成材三种基材分别约高出21.3%、39.1%、36.3%。

She screwed the lid back on to the bottle.

她将盖子拧紧在瓶子上.

He screwed the bolt in with an electric screw driver.

他用电动螺丝刀把螺栓拧紧.

I turned on my small wireless set shortly after the nine o'clock news had started.

我在九点钟的新闻节目开始后不久,就拧开我的无线电小收音机.

The equation for calculating minimum tightening torque on the crank pin nut is given.

给出了曲柄销联接螺母的最小拧紧力矩计算公式.

Tighten the N coupling nut on the AC servo motor side temporarily.

临时拧紧马达边的N型连接螺母.

Tighten the N coupling nut on the ball screw side.

拧紧丝杆边的N型连接螺母.

Silver storage cap should be tightened, placed 15 ℃ interior cool place.

银浆的存放应拧紧瓶盖, 置于<15℃室内阴凉处.

Never use pliers on a nut, while an adjustable spanner should only be used as last resort.

哪怕只有可调节的扳手才能奏效时，也一样不要用老虎钳来拧螺母。

The axial stresses in a group of bolts tightened on a joint of bridge truss were measured by using both longitudinal and shear ultrasonic waves.

本文利用纵横波相结合的方法对九江大桥联接螺栓的施拧轴力进行了群检测量。

Never use an impact bolter to tighten the wheel bolts.

请勿使用冲击螺栓扳手拧紧车轮螺栓。

Gather a ponytail into two sections and wrap them into small buns, the second in an opposite direction around the first. Bobby pin them in place and don't worry if they're too loose-the more effortless it looks, the better.Fact: Did you know?

将头发上下两区分别梳上马尾，然后将两个马尾拧在一起盘起来，用夹子固定，完全不用担心它散掉，而且看上去越蓬松越好。

Take me in straight, or I'll break your arm.'

赶快带我去见他, 不然我就拧断你的胳膊. ”

Japanese industrial conglomerate Hitachi Ltd. ( 6501. TO) introduced a NextAge robot last September to a factory outside of Tokyo that makes computer storage products. There, NextAge puts a cover over each hard-disk drive's fan and tightens screws.

2011年9月，日本大型产业集团日立公司（Hitachi Ltd.）在东京郊外一家生产计算机内存的工厂投入使用NextAge机器人，由机器人来给硬盘驱动器的风扇加上盖子并拧紧螺丝。

Pull off caps and unscrew fastening screws.

拉出盖板并拧开紧固螺钉。

Down, down... A final twist, a glance at the revolution counter, and he was done.

往下，往下……拧了最后一下，他看了一下旋转柜台，任务完成。