残余的例句大全

The distribution of residual stress of weld joints is analyzed.

并分析了焊接接头残余应力的分布规律.

Meanwhile, Liu Bei, the descendant from the rulers of the former Han, although in exile, striving to restore the power of Han, led his remaining soldiers to seek support from Sun Quan.

此时正在流亡中的汉皇室后代刘备也起兵欲兴汉室，率荆州的残余势力与江东的孙权结合。

The upper intercept age is the age of relict zircon, while the lower intercept age represents the formation age of diorite-porphyrite.

上交点年龄为残余锆石年龄，下交点年龄大致代表了闪长玢岩的形成时代。

No wastewater release in manufacture procedure, remaining and soil assimilate after degradation, no second pollution formed.

产品在生产过程中，无污水排出，降解后，残余物质与土壤同化，不会形成二次污染。

In the manufacture procedure of pressure vessel, the residual stress concentration may exist due to the causes of material selection, fabrication and welding.

在压力容器制造过程中，由于选材、加工及焊接等原因造成残余应力集中；

Factors Affecting Removal of Residual Aluminum in Portable Water

自来水中残余铝去除的影响因素

A residual life calculation method of assessing deteriorated rotor has been proposed.

讨论了在脆化影响下的转子残余寿命的估算方法.

Research on LTTE in Improving Fatigue Strengths of Welded Joints and Distribution of Residual Stresses

LTTE改善焊接接头疲劳强度及其残余应力分布研究

Among 30 cases using coil, 3 had residual shunt, 2 had dislodgement of coil.

用弹簧圈堵闭30例，3例术后发现残余分流，2例发生弹簧圈脱落。

Many wines contain a little residual sugar, while still tasting dry.

很多葡萄酒含有少量残余糖分, 但尝起来仍然是干的.

Therefore, it is interest to investigate residual stresses in aircraft aluminum parts.

因此, 研究航空铝合金构件中的淬火残余应力就显得非常重要.

After some steam stimulation s, high residual stress is accumulated in casing.

经过几轮蒸汽吞吐, 套管上会积累较高的残余应力.

The residual stress, strain and deformation near the trough were higher than those near the crest.

波谷处的残余应力 、 应变和变形大于波峰处.

Combination of self-developed IC image and PLC program make the operation simply and intuitively.

自主 研发残余图像与PLC程序相结合,操作简单直观.

The need for determining residual oil saturation ( S OR ) has existed.

测残余油 饱和度 的方法较多,但各有优缺点.

Morphometric analysis thearea of AS lesions , residual luminal area, average and maximal neointima thickness.

并用图像分析仪定量测量斑块表面积、动脉残余管腔面积 、 斑块平均厚度及最大厚度.

The residual-stress was measured by hole-drilling method. At the same time, the angular deformations of TWB were measured. It is shown that the simulation results are in accordance with the experimental results.

利用小孔释放法检测不等厚铝合金激光拼焊板的残余应力，并测量拼焊板的角变形，结果显示模拟值与实测值吻合良好。

Results After operation, bladder volume, maximum urine flow rate and compliance were increased, but residual urine/ bladder volume and detrusor pressure decreased. Uninhibitory contraction decreased in 15 patients.

结果手术后膀胱容量、膀胱顺应性、尿流率较术前增加，逼尿肌压降低，残余尿/膀胱容量比值较术前降低，无抑制收缩减轻。

Observation of the two groups before and after the treatment I-PSS score, prostate volume, bladder residual urine, the largest flow rate and detrusor contraction, and other indicators.

观察两组治疗前后I-PSS评分、前列腺体积、膀胱残余尿、最大尿流率及膀胱逼尿肌收缩力等指标。

There were significant decrease in frequency of nocturia and an increase in voided urine volume. Improvements were found in residual urine volume and maximum flow rate with statistical significance.

经观察患者夜尿减少，尿量增加，膀胱残余尿明显减少，最大尿流率和平均尿流率显著改善，而副作用小。