温度的例句大全

Numerical Analysis of Coupling Stress for Asphalt Pavement on Lean Concrete Base

贫混凝土基层沥青路面温度-荷载耦合应力分析

Based on the present research productions, Load stress and temperature stress of asphalt pavement with lean concrete base are additionally calculated and the influence of correlated factors is analyzed.

在现有研究成果基础上，补充计算了贫混凝土基层沥青路面的荷载应力和温度应力，并分析了各因素的影响。

Tests on thermal stress in asphalt cement sample and its numerical simulation

沥青混凝土温度应力试验及其数值模拟

Analysis of asphalt pavements temperatuer stress with asphalt treated base course

沥青稳定碎石基层沥青路面结构温度应力分析

The quality change of asparagus juice during storage were a close relation to temperature.

芦笋汁在贮藏过程中的质量变化与温度密切相关。

Storage temperature, light and package materials obviously affected the color stability of green asparagus juice during storage time.

贮藏温度、光照和产品包装材料对芦笋汁色泽稳定性产生很大影响。

The thermal conductivity of heat insulation materials, containing vacuum rubber board, asbestos board and quartz glass etc. was tested at different average temperature with RDL 1 automatic measuring apparatus made by ourselves.

用自行设计的RDL-1型物质热导率自动检测仪测试了真空橡胶板、石棉板等材料在不同温度下的热导率；

Study on the hatching temperature traits of Chinese Artemia eggs

中国卤虫卵孵化温度特性的研究

The main causes that resulted in the piers seriously cracking were inadequate arrangement of pier reinforcement, over-temperature-stress of the piers and higher values of static ice pressures.

闸墩配筋量明显不足、闸墩温度应力超限和静冰压力过大，是引起闸墩严重开裂的一些主要原因。

ST of Palm and BVP of fingers can be the sensitive parameters reflecting emotional arousal level of sailors.

手掌心温度和手指端血容可以作为帆船帆板运动员情绪唤醒水平的敏感性监测指标；

Experimental results showed that optimum temperature for the growth of M. arenaria was 29 ℃, but screening tests could be carried out between 25 to 33 ℃.

are（？）ia在紫花苜蓿上的最适发病温度为29℃，但抗病性鉴定筛选可在25～33℃之间进行。

For the aquiferous medium with the same oil content, the volatilization mass is higher and the residual ratio is lower with higher temperature and wind speed.

同种条件下，含油量越高，油品在介质中的残留率越高，对于同一含油率的含水介质，温度和风速越高，挥发量越高，介质中油品残留率越低。

In the scope of temperature the esterification can be regarded as the first order reaction approximatively.

结果表明，在所考察温度范围内反应可看作是假一级反应。

The finite model of injection molded parts with microstructure region considering latent heat can approximatively forecast the cavity temperature.

采用考虑结晶潜热的微结构件注射成型有限元模型能较准确地预测制品内部温度场分布。

The lower temperature of powder hot pressing process restricted or reduced the reaction between the quasicrystalline particle and metal matrix. Except the reaction product of quasicrystalline approximant Al_ 13 Fe_4, there was the oxidation of MgAl_2O_4 on Al_ 63 Cu_ 25 Fe_ 12 particle edge.

粉末热压复合过程中的较低温度限制或减缓了准晶颗粒与基体金属之间的反应，反应层的反应产物除了准晶类似相Al13Fe4外，还存在一定的MgAl2O4氧化物。

The method which is applied to distill column control system indicates that it has better adaptive ability and practical value.

将这种控制方法应用到蒸馏塔温度控制系统中去，研究表明，这种控制方法有较强的自适应能力，具有一定的实用价值。

The test results showed that under low ambient temperature and aphotic storage conditions jet fuel exhibited good color stability.

试验结果表明，喷气燃料在较低温度、无光储存条件下具有很好的颜色安定性；

Apery temperature controller of electric-calefaction based on single-computer A novel heater with a metal pipe was designed which is used encircling the discharge tube of a CuBr laser, resulting in homogeneous distribution of axial temperature.

设计了一种新颖的金属筒式加热器，使气体激光放电管轴向温度分布均匀。

It's curing temperature high and difficult to molding.

聚酰亚胺固化温度太高,并且难于成型加工.

For traditional thermal curing powder coatings, there has a big limit of high curing temperature.

但普通的粉末涂料存在固化温度偏高,不能用于热敏性底材,限制了其应用范围.