离心的例句大全

The characteristics of centrifugal pump unit given by pump specimen are obtained by testing with water.

泵样本上给出的离心泵组的特性都是用水试验得出的.

Self-priming centrifugal pump over-current components are: inhalation room, impeller, the chamber pressure is in three parts.

自吸离心泵的过 流部件 有: 吸入室, 叶轮, 压出室三个部分.

The improvement of Multiple centrifugal pump sealing protection ring for ammonia production was introduced.

介绍了合成氨生产中多级离心式打水泵密封保护环的改造.

Slip factor of centrifugal pumps is very important to theoretical head calculation.

滑移系数是计算离心泵理论扬程的关键.

The structure of dry gas seal, their application and modification are introduced.

用于离心泵的新型密封技术——干气密封的结构 、 使用及其改进.

The market on uneven centrifugal Products How should buy it?

那市场上参差不齐的离心泵产品应该如何选购 呢 ?

Main production gear pumps, pump, pump, high viscosity rotor pump.

主营生产齿轮泵 、 螺杆泵 、 离心泵 、 高粘度转子泵.

Discussion of Connection Mode of Impeller and Main Shaft in Centrifugal Fan

离心通风机叶轮与主轴联接方式的探讨

An Analysis of Ineffectiveness of Drive Gears in a Centrifugal Ventilator

某型发动机离心通风器传动齿轮失效原因分析

PD-type centrifuges are a new type, designed and manufactured according to the standard of pharmacy equipment GMP.

PD型离心机是依照制药装备GMP规范设计制作的新机型。

Technological alternation and application of dry gas seal in C-115 centrifugal compressor ( quondam seal system is mechanical seal) were introduced emphatically.

重点介绍了C-115离心式压缩机（原密封系统为机械密封）干气密封的技术改造及应用。

The Design of Centrifugal Compressor 3-D Impeller Based on CFX Software

基于CFX软件设计离心压缩机三元叶轮

Design of Unified Control System of Centrifugal Compressor Based on Torque Control

基于转矩控制的离心式压缩机综合控制系统的研究

The Application of Electronic Governor in Large Scale Turbine-Compressor Control

电子调速器在大型透平离心式压缩机中的应用

Compaction driven flow basins are believed as existing typical centrifugal flow regime of underground water.

压实流盆地被认为是具有离心流模式的地下水流系统.

The DNA of sample is hybridized with the oligonucleotide probes after being marked and the hybridization signal is detected in 2ml microtube.

样品DNA标记后与固定在膜条上的寡核苷酸探针在2ml离心管中杂交、检测获得杂交信号。

Design Means and Application of a Large Model Horizontal Decanters Centrifuge for DDGS

DDGS用大型卧螺离心机的设计与应用

In this paper a method has beed developed for the prediction of the efficiency of low specific-speed centrifugal pumps at design condition. The concept of abnor mal optimization is introduced.

本文提出了一种预测低比转速离心泵设计工况点效率的方法，并提出了病态优化的概念。

Numerical Simulation of Temperature Field in Ceramic lined Pipe for Centrifugal SHS Process

离心SHS陶瓷衬管温度场数值模拟

RNA samples are fixed onto the nylon strips, and then hybridized with the probe and the hybridization signal is detected in the 2ml microtube.

RNA样品被固定到膜条上之后，在2ml离心管中与探针杂交，然后检测杂交信号。