The effects of concentrations of aniline, oxidizing agent, doping agent, and the reaction temperature and period on the conductivity of the composite fiber were discussed.

So phosphoric acid as the doping agent, the PANI prepared by interfacial polymerization is more suitable for the electrode materials.

说明磷酸作为掺杂剂，界面法制备出的聚苯胺更适宜用作电极材料。

Conductive Polyaniline was prepared by chemical oxidation using aniline as the starting material and hydrocarbon as the doping agent.

以苯胺为主要原料，盐酸作掺杂剂，采用化学氧化法制备出导电聚苯胺。

Polyaniline of nanostructure was prepared by interfacial polymerization using hydrochloric acid as doping agent and reaction medium.

采用盐酸作为掺杂剂和反应介质，通过界面聚合制备纳米结构的聚苯胺。

Concentration effect of oxidant and doping agent on structure and properties of polyaniline

反应物中氧化剂和掺杂剂浓度对聚苯胺性能与结构的影响

The results show that they are different from the conventional PTCR ceramic materials in the following aspects: The effect of Sb doping density on resistance temperature characteristics of the ceramics materials is high;

结果表明：微量元素Sb的掺杂量对线性电阻温度特性影响较大；

Influence of Doping Density on Hot-carrier-effect in Grooved Gate PMOSFET

杂质浓度对槽栅PMOSFET抗热载流子特性的影响

The experimental results show that pulse width decreases with the increasing of quartz powder doping density and liquid depth.

实验结果表明，产生KrF短脉冲的宽度随酒精中掺杂石英粉末浓度、酒精悬浊液厚度、增加而减小。

The research results indicate that with the increase of doping density in channel, the hot carrier effect immunity becomes better.

研究发现，随着沟道杂质浓度的提高，器件的抗热载流子能力增强；

For the grooved gate PMOSFET, the study results prove that with the increase of channel doping density, the threshold voltage increases, the drain current driving ability decreases, and the hot carrier effect is suppressed, as in the planar device.

研究发现，随着沟道掺杂浓度的提高，与平面器件相同，槽栅器件的阈值电压提高，漏极驱动能力降低，抗热载流子效应增强；

The effect of different doping density and different testing temperature on the impedance spectrum is studied based on the simulation equivalent circuit within the electrolytic film of CeO2 base.

根据CeO2基电解质薄膜的内部模拟等效电路，研究了不同掺杂浓度及不同测试温度对阻抗谱的影响。

The principle of ion doping and valence compensation was adopted to develop a new catalyst Cu-Zn-Al-Zr which was derived from traditional Cu-Zn-Al catalyst by adding a small amount of ZrO_2 for MeOH synthesis under low pressure.

在Cu-Zn-Al甲醇合成催化剂中添加适量的氧化锆助剂，制得Cu-Zn-Al-Zr催化剂及表征其特性。

Activation of Fe Doping and Electrical Compensation in Semi-Insulating InP

半绝缘InP的铁掺杂激活与电学补偿

Doping and compensation in II VI semiconductors ①

Ⅱ-VI族半导体的掺杂与补偿

Finally HALL doping test on the material and substrate temperature were optimized.

最后用3ALL测试对材料的掺杂和衬底温度进行了优化。

For the lasers with symmetrical waveguide, the photon absorption of the non-active region material is proportional to the doping concentration of material, which causes serious absorption loss.

对称波导结构激光器中，非有源区材料对光子的吸收与其掺杂浓度成正比关系，吸收损耗比较严重。

Quantum Chemical Study on the Doping of Anode Material for Lithium-ion Battery and on the Reaction Mechanism of the Isomerization: HNC → HCN

锂离子电池掺杂正极材料的量化计算及氢氰酸协同反应机理研究

Neutron-transmutation doping for InP material

磷化铟材料的中子嬗变掺杂

The Quantum Chemical DV-X α Study on the Electronic Structure of Doping Cobalt Electrode Material for Lithium Ion Battery

锂离子电池掺钴正极材料电子结构的DV-Xα研究

Synthesis and Property of Al Doping Li-Ni-O Cathode Material for Li-ion Batteries

Al掺杂Li-Ni-O系列电池正极材料的制备与性能研究

The electron emission performance of liquid-liquid doping material was studied with emission surveyor designed in our laboratory. The effect of the doping method on the property and structure of tungsten cathode material was emphasized.

在自行设计的发射测量设备上，研究了液液掺杂材料的电子发射性能，着重阐述了掺杂方式对材料发射性能和结构的影响；