The surface chemical structure of activated carbon fibers ( ACF) was modified by cerous nitrate.

Effect of cerous nitrate on the activity of ATPase in tissues

硝酸铈对大鼠组织中ATP酶活性的影响

A novel solid complex of gelatin hydrolysate and cerous chloride was synthesized successfully, and the complex reaction between gelatin hydrolysate and rare earth cerium was verified by FT-IR.

报道了用水相法合成水解明胶铈配合物，采用红外光谱证明了水解明胶与铈的配合反应。

Research on Equivalent Bending Strength of Cermet Cladding Material for Clad in Press Condition

金属陶瓷硬质覆层材料覆层受压时的等效抗弯强度研究

Research on Wear Resistance of Cermet Cladding Material

金属陶瓷硬质涂覆层材料耐磨损性能研究现状

The effect of MoS_2 content on the friction and wear properties of copper-based cermet material was investigated. The result showed that MoS_2 was decomposed S and Mo during sintered;

研究了MoS2在铜基摩擦材料中的作用，结果表明，作为润滑组元加入的MoS2并非以MoS2的形式影响摩擦材料的性能。

Study on the Tribological Properties of SiC Ni Co Mo PbO High Temperature Self Lubricating Cermet Material

SiC-Ni-Co-Mo-PbO系高温自润滑金属基陶瓷材料摩擦学性能的试验研究

Study on the Tribological Properties of WC-Ni-Co-Mo-PbO High-Temperature Self-Lubricating Cermet Material

碳化钨－镍－钴－钼－氧化铅系高温自润滑金属陶瓷材料的综合性能研究

Research on Microwave Sintering Technology of Cermet Material

微波烧结金属陶瓷材料的工艺研究

The performance features of cermet material are comparatively analyzed. The cutting performances and application fields of some kinds of new cermet cutting tool materials including super fine cermet, coated cermet and super tough cermet are introduced.

分析比较了金属陶瓷材料的性能特点，介绍了超细微粒金属陶瓷、涂层金属陶瓷、超韧金属陶瓷等新型金属陶瓷刀具材料的切削性能及适用范围。

Tungsten carbide/ cobalt cermet coatings deposited by thermal spraying have been widely used in various areas to enhance the wear resistance of many types of engineering components.

热喷涂传统碳化钨/钴金属陶瓷作为耐磨涂层已得到广泛的应用。

In this paper, the recent developments of gradient cemented carbide and cermet are reviewed, with emphasis on their manufacturing processing, properties, and typical applications.

综述了国内外梯度硬质合金和金属陶瓷材料研究的进展情况，重点介绍了其粉末冶金制造方法、性能特征和典型应用开发。

New Development of Functionally Gradient Cemented Carbide and Cermet

功能梯度硬质合金和金属陶瓷材料研究的新进展

An Investigation on Critical Grit Size of Chromium Carbide Cermet Formed by SHS Using Microcomputer to Measure the Grit Size

碳化铬金属陶瓷临界磨粒尺寸效应的研究应用微机检测磨料粒度组成

Abrasive Wear Mechanism of SHS Coatings of Chromium Carbide Cermet

碳化铬SHS熔覆层的磨料磨损机理研究

The synthesis of butyl acetate with acetic acid and butanol as reactants and ammonium ceric sulfate as catalyst was studied. Through experiment, the influencing factors of reaction were investigated. The results showed that the esterification rate is over 93.4%.

研究了以硫酸铈铵为催化剂，乙酸和正丁醇为原料合成乙酸正丁酯，通过试验确定了最佳合成条件，结果表明，在适宜条件下其酯化率可达93.4%。

Catalytic Synthesis of Fructone-A and Fructone-B by Ammonium Ceric Sulfate

硫酸高铈铵催化合成苹果酯-A和苹果酯-B

The study of determination of molybdenum by reduction with diamine sulfate ane titration with ammonium ceric sulfate

用硫酸联氨还原、硫酸铈铵滴定钼的研究

The rate of reclamation of cerium is above 95% in the ceric hydroxide. The ratio of CeO_2/ TREO is about 83% in the ceric hydroxide.

用氨水回调，氢氧化铈沉淀中，铈的收率大于95%，CeO2／TREO约为83%。

The solubility of the precursor ceric hydroxide in nitric acid, recycle of crystal mother liquor of ammonium ceric hydroxide, and recovery method for cerium in mother liquor have been investigated.

讨论了前驱体氢氧化铈的硝酸溶解性能、硝酸铈铵结晶母液的循环利用、结晶母液中铈的回收方法。

A green method for ceric hydroxide synthesis with cerium carbonate and hydrogen peroxide as main raw materials is reported, and two products, ceric hydroxide and sodium acetate, are obtained.

研究了氢氧化铈合成的绿色方法.以碳酸铈和醋酸为主要原料，最后获得氢氧化铈和醋酸钠。