Accurate prediction of BHA deflecting capacity is very important for precise well trajectory control.

These systems must be capable of containing or deflecting falling objects.

这些装置必须能够承受或转移落物的冲击力.

The calculation result is in accordance with the productivity formula for deflecting wells of F . S . U.

与前苏联斜直井产能公式相比较,计算结果一致.

Stiffness is the ability of a material or shape to resist elastic deflection.

刚度衡量的是材料抗弹性形变的能韩国乐天饮料系列力.

Model Y could reduce the deflection of crafts vat by being used two series machines.

本机型可双机串联使用,减少工艺缸差.

Physicians experience smoother deflection and greater predictability.

医生能调节更平滑的弯曲,并有更大的可预见性.

Starlight passing close to the sun should experience some deflection.

从太阳近旁通过的星光会受到某种偏折.

Each interaction produces an energy loss and deflection.

每次相互作用都引起粒子能量损失和方向偏转.

While at the corner there are corner conditions: deflection or reaction also.

沿每个边有两个边界条件: 挠度或等效剪力,斜度或弯矩应分别等于沿边界的已给值.

Thermal diffusiviities of BaTiO _ 3 materials are measured by laser photothermal deflection technique.

利用激光光热偏转技术测量了钛酸钡材料的热扩散率.

In this article , by applying several layout of prestressing tendon, stress and deflection is calculated.

通过采用几种不同的预应力筋布置方式, 对应力进行计算,得出一种优化的布置方式.

Combining the results of theoretical and experimental analysis, the balancing strategy of elastic deflection is preferential.

综合理论与实验对比分析结果, 在实际弯曲转子的平衡中应优先采用平衡转子弹性挠曲的平衡策略.

These springs supply a reacting force proportional to the deflection.

这些仪表提供了与偏差成正比的恢复力.

The load bearing capacities and deflection of the steel crane girders were calculated.

对吊车梁的承载能力和挠度进行了验算.

Different sand carrying ratio of gravel filling is used in different well deflection and oilfield.

在不同油田、不同井斜使用不同的砾石充填携砂比,对充填系数都有着很大的影响.

The steel frames were considered have reached their ultimate state when excessive deflection or fracture occurred.

而在研究过程中若构架产生过大变形或断裂时则视其已到达极限破坏.

The touch mode capacitive pressure microsensor based on the small deflection hypothesis is analyzed.

在小挠度变形假设的基础上对接触型电容式微型压力传感器进行分析.

This paper also introduces the stress losses of post-bar and deflections of beams before and anchorage.

文中还介绍了双预应力混凝土梁变形的特点和有关预应力损失问题.

Measuring crank deflections for per cylinder, in accordance with diesel works requirements and criterions.

主机各缸臂距差均在主机厂要求的范围内,符合规范的要求.

The slender members which result may permit deflections which are functionally or visually unacceptable.

这样得到的细长构件,可能产生不符合功能要求和视觉要求的挠度.

Equations are established based on the principle of deflections consistency.

根据板簧变形协调原理,导出相应的方程.