Mental Health Status of Medical Students Before and After Graduating Allotting System Reform

Study on the Risk Mechanism in the Virtual Enterprise Profit-allotting

动态联盟收益分配中的风险机制研究

CAM Data Analysis and Processing of Allotype Plastic Profile Extrustion Dies

塑料异型材挤出模CAM数据分析与处理

Design of Large Cantilever Top Beam in Allotype Double as Footbridge

兼作人行天桥的新型大悬挑异型盖梁设计

The CAD/ CAM System Framework of Allotype Plastic Profile Extrusion Die

塑料异型材挤出模CAD/CAM总体框架

Development of Integrated and Open CAD System for Allotype Plastic Profile Extrusion Die

塑料异型材挤出模具集成开放式CAD系统研制

The young people remain perplexed after much thought, thought oneself diligently, will not set firm resolve tomorrow to have to go allout only then good;

年轻人百思不解，以为自己不够努力，下定决心明天要更卖力才行；

Lily: You know, Eleanor always goes allout. speaking of going allout...-

allout:竭力的，全面的你知道，Eleanor是喜欢彻底的，说到彻底。

Or this is gonna blow up into an allout mob war.

否则事件会演变成全面的黑社会斗争

I'll sleep in my clothes. It's an allout war situation.

我就这么和衣睡着吧，现在是全力以赴的战时状态

The accuracy between the predicted and actual times was in the allowable error range of engineering.

预测的滑坡时间与实际的滑坡时间的误差在工程允许精度之内。

It is necessary to decide a reasonable sampling volume within a limit of allowable error.

因此，在允许接受的误差范围内，有必要确定最合理的采样体积。

Frame Synchronization and Allowable Error Analysis

帧同步及其容错分析

Analysis of Error Sensitivity and Allowable Error of Optical Film, and Computer Controll in Production

光学薄膜的误差、允差分析及生产过程中的计算机控制

All the testing results of the three modules meet design requirements within the range of allowable error.

测试结果表明，在误差范围内，模块均满足设计要求。

Thus the allowable error of area measurement was setted.

确定出该仪器量测图形面积时的容许误差；

After validation, the system can reach the expected effect within the allowable error.

经过验证，误差允许内系统可以达到预期效果。

Analysis of allowable error in launching air-to-air missile

空对空导弹发射允许误差分析

The allowable error for the most importance of objective.

对最为重要的目标函数，其允许误差应最小。

On the synthesis of the spatial RSSR crank-rocker mechanism in accordance with allowable pressure angle

空间RSSR机构按许用压力角、极限位置和行程速比的综合

The available method for determining basic size of cam mechanism according to its allowable pressure angle is lack of appropriateness.

现有按许用压力角确定凸轮机构基本尺寸的方法欠妥。