MPA的例句大全

Conclusion The results show that MPA can be useful to various tumors in impoving life quality.

结论甲孕酮(MPA)可以广泛用于各种肿瘤的化疗期间,来改善患者生活质量.

According to experimental results, the early stage strength index should be 18.5～26 MPa.

根据试验结果, 该龄期强度值应在18.5～26MPa之间.

So this model is not applicable when pressure is above 3.8 MPa.

因而,该模型不能应用到3.8MPa以上的高压力范围.

Pressurize the vessel to e . g . 0.2 MPa ( overpressure ) and vent.

对反应釜加压如加压至0.2MPa ( 超压 ) 然后放空.

For MPP , MPH, MPA series S-correction capacitor, the permissible lp-p value is also listed.

MPH 、 MPA系列S校正电容器给出了额定峰峰值电流.

METHODS Zedoary nano-liposomes were prepared by micro-jet technique ( jet dia . 50μ m, pressure 120 MPa ) .

方法采用微射流技术在射流直径50μm和压力120 MPa 条件下制备莪术油 纳米 脂质体制剂.

Cell surface Fas expression in cancer cells increased after treated with MPA.

MPA作用后结肠癌细胞表面Fas表达 显著增强.

The compressive strength was as high as 350 MPa.

抗压强度高达350MPa以上.

Dongguashan copper mine has such characteristics as high stress ( 30~38 MPa ) and rockburst possibility.

冬瓜山铜矿深井具有高应力 ( 30~38MPa)、存在岩爆倾向的特点.

Amphoteric polyacrylamide as paper reinforcer was synthesised with G-acrylamide , acrylic acid , nitrile, accelerant-MPA as raw materials.

以丙烯酰胺、丙烯腈 、 丙烯酸和促进剂MPA为原料合成两性聚丙烯酰胺纸用增干强剂,并讨论了各反应条件对产品性能的影响.

It is measured at a speed of 2 m / s under load intensity of 1.96 Mpa.

它是在载荷集度为1.96Mpa和速度为2m/s时测得的.

MPa and nearly horizontal, the jacking strength is about 6.

最小主应力状态为近水平; 测点洞段围岩的抗劈裂强度一般为6.

The recovery of CO _ 2 injection core displacement is 48.15 % at 22.64 MPa.

芳48断块岩心在22.64MPa下注CO_2采收率为48.15%.

The ore-forming pressure was small , ranging from 5 to 30 MPa.

热液压力不大,变化在5—30MPa之间.

Results: MPA has its own characteristics in symptoms, laboratory and pathology manifestations.

结果: MPA在 临床表现, 实验室检查,辅助检查及病理活检等方面各有特点.

Novel rare-earth contained bismuth telluride thermoelectric materials were prepared by solvothermal synthesis at 180 ℃ using bismuth chloride, tellurium powder and lanthanum chloride or oxide as starting materials, and the following hot uniaxial pressing ( HUP), 400 ℃, at 50() MPa for 1h.

以氯化铋、碲粉、氯化镧或氧化镧为原料，采用180℃溶剂热合成和400℃、50MPa、1h热压技术制备了含稀土的新型Bi2Te3基热电材料。

Results: The colporrhagia stopped within 3 days in the group treated with MPA and 83.33% abnormal echo with less than 1 cm could not be seen by the ultrasonography after the withdrawal bleeding.

结果：应用安宫黄体酮后3d内阴道出血停止，撤退出血后B超示宫腔内1cm以下的异常回声消失率达83.33%，与对照组比较差异有显著意义。

When ultimate strength is at 1250~1300 MPa the toughness of the weld is at its maximum.

当焊接强度处于1250～1330MPa之间时,焊缝的韧性最高.

MPA fermentation needs high dissolved oxygen and is not very sensitive to shearing strength.

霉酚酸的发酵对溶氧的要求较高,而对剪切力不敏感.

Compared to the normal wire drawing technology in room temperature, the cryogenic wire drawing technology showed remarkable effect: tensile strength was improved nearly 400 MPa, micro vickers hardness was enhanced 74 HV 4.9N, in the meanwhile, toughness was almost changeless.

研究表明，在相同的拉丝条件下，与常温工艺相比，深冷工艺能大幅度提高钢丝的综合力学性能。抗拉强度进一步提高近400MPa，显微硬度进一步提高74HV4.9N，而抗扭次数及伸长率基本不变。