MPA的例句大全

Further more, it is showed that 20-30% of coal mixed in MSW and 15 MPa of briquetting pressure are suitable for preparation of RDF with optimum specifications.

在研究条件下，向MSW中掺入20%～30%的煤、15MPa左右的成型压力是制备RDF的较优条件。

The design of 105 MPa sulfate resistant casing head

105MPa高压深井抗硫套管头设计

The inspection results indicated that the uniform diameter of pure sand-gravel columns in mud and silt reached 55~ 82 cm, and the boring core sample strength of grouting column reached 4.3~ 11.4 MPa at the age of 28 d.

检测结果表明，挤入淤泥和粉土中的纯砂砾柱平均直径达到55~82cm，28d龄期时水泥砂砾灌浆体取芯的抗压强度达到4.3~11.4MPa。

Novel rare-earth contained bismuth telluride thermoelectric materials were prepared by solvothermal synthesis at 180 ℃ using bismuth chloride, tellurium powder and lanthanum chloride or oxide as starting materials, and the following hot uniaxial pressing ( HUP), 400 ℃, at 50() MPa for 1h.

以氯化铋、碲粉、氯化镧或氧化镧为原料，采用180℃溶剂热合成和400℃、50MPa、1h热压技术制备了含稀土的新型Bi2Te3基热电材料。

The tensile strength of the joint of pulse submerged arc welding is 50 MPa higher than that of ordinary submerged arc welding, which is about 12% higher. Under the same heat input, there is failed test piece in the ordinary submerged arc welding.

脉冲埋弧焊比普通埋弧焊在抗拉强度上增50MPa，大约12%左右，普通埋弧焊在与脉冲埋弧焊同样的热输入条件下出现了不合格试件。

Under the 100 MPa boundary force, the proportion of tectonic pressure in UHP is about 20%-35%.

在边界力为100MPa的情况下，构造压力在超高压中所占的比例约为20%～35%；

Total length of linked production pipes are about 1500 7000 m , side wall pressure is over 20 MPa.

采油油管连接长度约1500～7000m, 管壁承压20MPa以上,管子内外壁受油、泥严重污染,各类缺陷多,危害大.

MPA ， master of engineering ， and 75 bachelor's degree programs.Chongqing University is in possession of 16 state level key subjects and key construtted subjects under the state "Project 211" ， 34 provincial or ministerial level key subjects.

学校拥有国家重点学科及国家“211工程”重点建设学科16个；省部级重点学科34个；

MPA Training Centre of Wuhan University

武汉大学MPA教育中心

QM anchor system and 1860 MPa strand are applied.

锚具采用QM锚 具体系,钢绞线为1860MPa级钢绞线.

When replacement of cement with L-RHA equals 10 % ～20 %, the compressive strength of HSC increases over 10 MPa.

当低温稻壳灰替代10%～20%水泥时, 可提高高强混凝土抗压强度10MPa以上.

The results showed that in rolling stock deforming zone the equivalent stress gradually increased along the direction of rolling and came to maximum value ( 95.20 MPa) nearby neutral face, than gradually decreased;

结果表明在轧件变形区内，等效应力沿轧制方向逐渐增大，在中性面附近达到最大值（95.20MPa），后又逐渐减少；

QCS-01 is one of Co-Mo oxide-based WGS reaction catalysts which can operate under high pressure up to 9 MPa.

其中QCS-01型催化剂可用于高达9.0MPa压力的变换反应系统。

Compared with its domestic and overseas counterparts, QLT 17 possessed superior processability and physical properties, such as tensile strength of 13.8 MPa, elongation rate 653% and dielectric constant 2.2 at 50 Hz.

与国内外同类树脂相比，QLT17具有优良的物理性能和加工性能，拉伸强度为13.8MPa，断裂伸长率为653%，介电常数（50Hz）为2.2。

The NHC is an efficient modifier to make HTPB propellant obtain a high burning-rate of 80~ 100? mm/ s ( 9.8? MPa).

NHC是使丁羟推进剂获得80～100mm/s（9.8MPa）高燃速的有效调节剂。

T is demonstrated through cold and hot state tests on the characteristics of feeding the bottom injectant for the converter that the pressure for powder injection shall exceed 0.5 mpa;

通过冷态和热态试验、研究转炉底喷粉剂的输送特性，初步认为：喷粉压力应大于0.5MPa；

The temperature and pressure ranges for the gas condensate accumulations in the basin are 70-130 ℃ and 35-60? MPa, respectively.

塔里木盆地凝析气藏富集温度为70～130℃，压力范围为35～60MPa。

Specifications Temperature: 173K 1073K continuously adjustable, accuracy ± 0.5 2K, Pressure: atmosphere to 10 MPa, Vacuum: 10 6 torr, Phases: gas solid and liquid.

性能指标温度：从173K－1073K连续可调，精度±0.5－2K；压力：常压至10MPa.真空度：10－6tor：相态：气固相及液相。

The tensile strength of drawing wire can reach 1421 MPa. And the highest relative conductivity can reach 30% IACS ( International Annealed Copper Standard). The effects of cold drawing on the properties of electrode wire have been investigated.

拉制硬态电极线抗拉强度可达1421MPa，相对导电率最高可达30%IACS（国际退火（软）铜标准）。

It has been tested at 700 MPa confining pressure and worked at 600 MPa and 400℃.

最高实验压力达600兆帕,最高温度400℃.