冷却的例句大全

The hot, light air goes up higher and higher until it becomes cold.

热的轻的空气越升越高直到它冷却下来.

Annealing: Heating to 830 ~860 Holding time 1 ~3 h, Colding in furnace.

退火: 加热至830～860℃,在此温度停留1～3小时, 在炉中冷却.

Annealing: Heating to 780 ~850 Holding time 1 ~3 h, Colding in furnace.

退火: 加热至780～850℃,在此温度停留1～3小时, 在炉中冷却.

Annealing: Heating to 830 ~880 Holding time 1 ~3 h, Colding in furnace.

退火: 加热至830～880℃,在此温度停留1～3小时, 在炉中冷却.

Annealing: Heating to 800 ~850 Holding time 1 ~3 h, Colding in furnace.

退火: 加热至800～850℃,在此温度停留1～3小时, 在炉中冷却.

Annealing: Heating to 750～780℃ , Holding time 1～3 h, Colding in furnace.

退火: 加热至750～850℃, 在此温度停留1～3小时,在炉中冷却.

Blanks then are quickly transferred into a cooled stamping die using an automatic feeding system.

板料随即快速转移至安装自动冷却系统的冲压模具.

Exyernal motor oil pump enable good ventilating and cooling conditions, safety operation and prolonged service life.

由于电机、油泵外置,其通风冷却条件好, 运行安全,寿命长.

The current version needs lots of space to house and cool its electronic control boards;

当前这个机型需要很大空间来存放和冷却其电子控制面板。

Experimental investigation of behavior of steel beams with axial restraint in cooling phase at elevated temperature

高温下约束钢梁冷却阶段的性能试验研究

To remove strains and reduce coarse crystalline structures in ( metal ), especially by heating and cooling.

除去特点并减少 ( 金属 ) 里的粗晶结构, 尤指用加热和冷却的方式.

Loosen the coolant pump pulley bolts while the belt is still tight.

在皮带仍然紧时,放松冷却水泵滑轮螺栓.

Numerical study on adiabatic wall cooling effectiveness and convective heat transfer coefficient of effusion cooling

致密孔阵气膜冷却绝热温比和对流换热系数的数值研究

Check oil cooler internal anti-corrosion ( zinc ) coatings, the need to redo.

检查油冷却器内部的防腐 ( 锌 ) 涂层, 必要重做.

Insulation used to prevent heat diffusion, as from a steam pipe.

蒸汽一进入排气管就要冷却.

Usage: It is a corrosion-proof scale preventative agent of superior effect for industrial cooling water system.

用途: 作为工业循环冷却水系统的阻垢缓蚀,其效果非常优异.

After cooling, during the sorting phase, the tiles'dimension and flatness are checked by electronic equipment.

瓷砖冷却后, 在分类阶段, 采用电子设备检测瓷砖的尺寸和平整度.

At the distance of about 0.15 m from the scrubber-cooling ring, the gas temperature is developed.

在距洗涤冷却环下方约0.15m处，气体温度已降至热质传递的平衡值附近。

The influence of the cooling field on the exchange bias in ferromagnet/ antiferromagnet bilayers system

铁磁/反铁磁双层膜中冷却场对交换偏置场的影响

A Study on the Low Aerodynamic Noise Performance Analysis and Control of Engine Cooling Axial Flow Fan

发动机轴流冷却风扇低噪声气动性能分析与控制研究