提出的例句大全

Abstract: A paint vapour treatment by means of blowing and drawing ventilation in an airtight workroom is suggested in the article. Optimal ventilating parameters of push-pull flow dust control in large spaces

文摘：提出在密闭喷漆作业间，采用吹吸式通风法对作业间的漆雾进行治理的方案。吹吸气流控制大空间粉尘最佳通风参数的研究

A paint vapour treatment by means of blowing and drawing ventilation in an airtight workroom is suggested in the article.

提出在密闭喷漆作业间，采用吹吸式通风法对作业间的漆雾进行治理的方案。

The vibration on blower pipe system of boiler is analyzed, some measures of decreasing vibration are presented in order to reducing noise of boilers.

分析了锅炉引风管道系统的振动。为了降低噪声，提出了减少振动的一些措施。

In view of problems in blowdown system of boiler, some idea about design and operation are put forward.

为消除锅炉排污系统存在的隐患，保证安全运行，提出了系统设计和操作方法的一些看法和建议。

A method by integrating partition of threshold switching surfaces with interval computation was proposed to get the conservative approximation of a timer event's irregular switching surface, which can solve the trouble when there exist timers in continuous blocks of hybrid systems and is hard to discrete.

针对混合系统的连续部分存在定时器时难于进行离散模型近似的问题，提出了一种结合阈值切换面划分和变步长区间计算的解决方案。

And on the IGBT mode, the method of calculating the paralle capacitor and the blocking capacitor is presented.

在对IGBT管子模型的研究的基础上，提出了IGBT并联电容、隔直电容等主电路参数的计算方法。

In the design of blocking voltage capability, the simplified formulas for the base region thickness and for the choice of doping concentrations are proposed.

提出了阻断电压设计中关于基区宽度和基区杂质浓度选择的简化公式。

A novel blind joint angle and delay estimation method in uniform circular array based on trilinear model was presented.

提出了均匀圆阵中一种盲联合角度和时延的估计方法（BJADE）。

The paper introduces the operating principle of screw cone mixer blender and puts forward some measures to solve existing problems, thus basically achieving the goal and requirements for the expansion and rebuilding.

简要叙述了螺旋锥形混合机的工作原理，对其存在的问题提出了相应的解决措施，基本上达到了改造的目标和要求。

An optimization model on life cycle net energy cost related to renewability of cassava-based ethanol blended gasoline fuels was given in this paper.

提出一个新的考虑燃料可再生性的净能源成本指标，燃料指标值越低表明燃料的总体表现越好。

Submitting and Analysis of the Firing Value Formula in the Electric Blasting Series Circuit

电爆网络串联准爆公式的提出和分析

This paper analyzes the domestic and international research of presplit blasting Air-deck Charge technology, and put forward the necessity and urgency of using this technology in the highway construction which through the mountains.

论文分析了国内外预裂爆破空气间隔装药技术的研究现状，并提出了在山区公路修建中使用该技术的必要性和迫切性。

A damage identification method for the continuum structures with making use of the blanketing effect is proposed in this paper.

提出了一种基于覆盖效应的连续体结构损伤指示方法。

When IRI was replaced with standard deviation(σ) of profilometer, another equation of DAF can be expressed with σ and vehicle velocity. With the riding quality evaluation ranking criterion, the dynamic amplification factor of each rank was also achieved for bituminous pavement and cement concrete pavement.

引入IRI与连续平整度仪测定的标准差σ的关系后，得到动荷系数与σ及车速的关系式，最后结合沥青路面和水泥混凝土路面行驶质量评价标准，提出各路面等级的动荷系数。

The ideas such as digital phase-locked integration, program-mable PID control and variable cycle speed stabilizing criterion etc, are proposed and applied to the design of the control of rotating platform system.

提出数字锁相积分、可编程PID控制及变周期稳速判据等概念，并应用于转台控制器设计。

A new method in design of arbitrary order analog fractance circuit based on binomial expansion is presented.

提出一种通过二项展开式设计任意阶模拟分抗电路的新方法。

This paper describes an efficient optimality criterion method for the optimum design of antenna structure.

本文提出了一种有效的结构优化方法&导重准则法。

Suggestions on the deformation control criterion for deep excavations are put forward.

并对随深度增加后深基坑的变形控制标准提出自己的观点。

The sunspot number of Cycle 21 attained its peak 165.3 at 1979.9. To judge on various prediction results of Cycle 21, the criterion 165.3 ± 16.5 and 1979 ± 0.5 year are suggested.

第21周的太阳黑子数于1979.9（1979年12月）到达它的峰值165.3。本文提出用165.3±16.5和1979.9±0.5年的容许变幅，来检验第21周多种多样的预测结果。

Furthermore, an improved detection algorithm based on the minimum mean square error criterion is presented.

本文针对此类调制信号，分析了其独特性质，并基于最小均方误差准则提出了一种改进的接收端检测算法。