A new logarithm linearization compensation method of thermistor without temperature drift is proposed in this paper.

The characteristic of the logarithm 6.3214 is 6.

对数6.3214的首数是6.

The decimal part of a logarithm. In logarithm 2.95424, the mantissa is 0.95424.

尾数对数的小数部分.如在对数2. 95424中, 尾数是0.95424.

In this paper, we mainly study signatures of knowledge of discrete logarithm with coefficient.

本文主要研究了带有系数的离散对数知识签名.

Based on the discrete logarithm, this paper proposes a group signature schemes.

基于离散对数给出了一种组签字方案.

It is repressed as the logarithm of the opacity of the material.

在印刷方面,‘学密度’通常简称为‘度’.

Methods Far sight was examined through E Standard Logarithm Eyesight Table.

方法远视力检测使用E字标准对数视力表进行常规检查.

Returns the logarithm ( base 10 ) of a value.

返回某个值 ( 以10为底 ) 的对数.

The decimal part of a logarithm. In the logarithm 2.95424, the mantissa is 0.95424.

尾数对数的小数部分. 如在对数2.95424中, 尾数是0.

And the grey level in middle domain is revised with logarithm function as nonlinear transformation function.

用对数函数做非线性变换函数来修正中间灰度区域.

Figure 2 shows the logarithmic-conversion curve that defines the look-up table's values.

图2表示确定该 查找表 值的对数转换曲线.

This paper deals with the interpolation of mixed logarithmic splines with deficiencies 1 and 2 respectively.

本文讨论了亏度分别为1和2的混合对数样条的缺插值问题,并给出了问题的解的存在唯一性定理和误差估计.

A new design method of the broadband logarithmic operational circuit is presented.

提出了一种新的宽频带对数运算电路的设计方法.

Once established, early rust increase is logarithmic.

一旦定殖后, 早期锈菌的增长是对数性质的.

Our perception of brightness is logarithmic, not linear.

我们对亮度的感受特性是对数性的, 而非线性的.

The unoccluded spores were killed in a logarithmic manner in 5.5 hr.

未封闭孢子在5.5小时内以对数级被杀灭.

After initial logarithmic progress growth plateaued sharply.

初期的上升进程之后,发展陡然平稳下来.

The construction of a logarithmic diagram is straightforward.

绘制对数图是很容易的.

The results showed that m-nitrobenzene could induce the DNA strand breaks with significant logarithmic dose-effect relationship.

结果表明:间二硝基苯能够导致生殖细胞DNA链断裂,而且其受损率与剂量具有明显的剂量效应关系.

Groove is a series of recessed logarithmic spiral.

槽型是一系列凹进的对数螺线.

The principle and device of machining logarithmic spiral profile shaft with form milling cutter are introduced.

介绍了用成形铣刀加工对数螺线型面轴的原理和装置.