cooling的例句大全

The area required for a cooling pond can be estimated for the appropriate climatic condition.

冷却池所需要的面积,可以根据具体的气候条件加以估算.

The theme describes the welding technology characteristic of the stainless steel cooling pipe of condenser used automatic impulse argon-arc welding in power plant. This will provide the welding technical reference to use such condenser of thin wall stainless steel and automatic impulse argon-arc welding.

主要讨论了火力发电厂凝汽器不锈钢冷却管采用自动脉冲氩弧焊时的焊接工艺特点，为今后薄壁不锈钢管自动脉冲氩弧焊的应用提供焊接技术参考。

It matches international well-known argon-arc welding machine and welding torch cooling system, guaranteeing long-term continuous production.

配备的国际知名品牌氩弧焊机及及焊枪冷却装置，可保障生产的长期持续进行。

Using of Argon Arc Welding in Cooling Water and Oil Pipes

氩弧焊在减温水管及油管道焊接中的应用

With increasing value of height width ratio of water channel K, both the velocity of water flow in the cooled jacket and equivalent heat transfer area of water channel section decreased so that the cooling capacity of cooled jacket was weaken.

水道高宽比K值对水冷套冷却能力的影响规律是：K值增加，水道内水流速、等效传热面积均减小，水套的冷却能力降低。

A sphere large-power short arc xenon lamp is used as the light source of this equipment. Deep ellipsoidal optical focusing system, cooling system and power source are designed reasonably.

该设备以大功率球形短弧气体放电氙灯为光源，设计了合理的光学聚焦系统、冷却系统及供电系统。

Application Research of Pipe Cooling Technique to Prevent Crack in Large-scale Aqueduct

水管冷却技术在大型渡槽防裂中的应用研究

The method is to add a baffle in the cooling channel, which is apeak the X-Z surface, located in the half of the anode surface and the clearance against the out side is 2 mm.

其具体的形式为在冷却通道中加一挡板，挡板垂直于X-Z平面，位于阳极的平分面上，挡板与外壁面的间隙为2厘米。

Objective: To observe the effect of antidotal decoction for cooling blood in treating all sorts of dermatosis.

目的：观察自拟凉血解毒汤治疗皮肤病的疗效。

Calculation of Laser Amorphism Cooling Rate on Pd-Cu-Si Alloys Surface

钯-铜-硅合金表面激光非晶化冷却速率的计算

The cooling and heating energy consumption and use cost occupy 60-70% in all the air conditioning system, different schemes are widely different. It brings more and more serious energy and environment issues that have aroused the strong attention of the experts in HVAC industry.

而空调冷热源的能耗及使用成本占整个集中空调系统的60～70%，不同冷热源方案的差别也很大，随之带来的日趋严重的能耗和环境问题一直是业内人士关注的焦点。

Application of Weak Alkalization Technique to Inner Cooling Water of Generator

发电机内冷水微碱化技术的应用

Application of Jet Type Air Cooling Condenser in Fengzhen Power Plant

空冷喷射式凝汽器在丰镇电厂的应用

On the effect of condensing worm on vacuum cooling

凝水器对真空冷却效果的影响分析

Using these fault diagnosis rules, the fuzzy neural network model has been established with four characteristic parameters, namely condensing pressure, evaporating pressure, cooling capacity, compressor shaft power as system input and fault patter as system output.

并基于综合后的故障诊断规则，建立以冷凝压力、蒸发压力、制冷量、压缩机的轴功率等4个特征参数为系统输入量，故障模式为系统输出量的模糊神经网络模型。

Optimization of Surface Condenser TTD of Indirect Air Cooling System

简接空冷系统表面式凝汽器端差的优选

Testing and Research on Operation Performance of Indirect Dry Cooling System with Surface Condenser

表面式凝汽器间接空冷系统运行性能试验研究

The design, manufacturing, testing and application status of jet type air cooling condenser in Fengzhen Power Plant were analyzed and studied.

对空冷喷射式凝汽器在丰镇电厂的设计、制造、试验及使用情况进行分析研究。

Design and experimental research of cryostat for cooling Ti: Sapphire crystal

冷却钛蓝宝石晶体低温恒温器的设计与实验研究

Two main section-evaporation and cooling crystallization was reconstructed in Double Decomposition Reaction Produce KNO3, and production of reconstruction anteroposterior was contrasted.

对复分解法生产硝酸钾工艺中的两个主要工段：蒸发、冷却结晶进行改造，并对改造前后的生产情况进行了对比。