合金的例句大全

1、

Differential scanning calorimetry ( DSC) was employed to investigate the relation of deformation rate and eutectic melting activity energy of AZ91D magnesium alloy by SIMA method.

采用DSC技术研究了SIMA法制备半固态AZ91D镁合金坯料过程中形变率与共晶熔化激活能的关系。
来源：互联网摘选
2、

Effect of Rare Earth Element on Properties of Al-Si Eutectic Alloy

稀土La（镧）对Al-Si共晶合金性能的影响
来源：互联网摘选
3、

Effect of Al element on the isothermal oxidation behavior of Ti-Si eutectic alloy

Al元素对Ti&Si共晶合金恒温氧化行为的影响
来源：互联网摘选
4、

Study on Crystallization Process and Microstructure of Ti-Si Eutectic Alloy Systems

钛硅共晶系合金结晶过程与微观形貌
来源：互联网摘选
5、

Influence of side ultrasonic treatment on solidification characterization of Al-Si eutectic alloy

侧部导入超声处理对共晶Al-Si合金凝固特性的影响
来源：互联网摘选
6、

Eutectic furnace is a special equipment based on the eutectic principle, packaging chip according to different eutectic technological requirements of welding alloy materials under a vacuum or inert gas protection environment.

共晶炉就是基于共晶原理开发的专用设备，在真空或惰性保护气体环境中按照不同焊接合金材料的共晶工艺要求，完成芯片的封装。
来源：互联网摘选
7、

The analysis result indicates that the interaction of unlike atoms is strengthen in the the eutectic point.

分析表明，在Zn-Bi合金中异类原子间的相互作用在共晶点处显著加强。
来源：互联网摘选
8、

According to the results of DSC and microstructure analysis, the more Al content, the higher melting point of the alloy, but the more α phase dendrites, the less eutectic cementite.

从差示扫描量热分析和显微组织得出：随含铝量的增加，合金的熔点提高，α相枝晶增多，晶间的共晶体减少。
来源：互联网摘选
9、

When the pulling rates was low as 1 mm/ min, three-phase eutectic structure was observed and characteristic of directional solidification could be found in longitudinal section.

当下拉速率为1mm/min时，合金组织呈现三相共晶结构，纵截面有定向凝固趋势。
来源：互联网摘选
10、

Eutectic Structure of Binary Mg Li Alloy During Directional Solidification

定向凝固条件下二元Mg-Li合金共晶组织的研究
来源：互联网摘选
11、

Superplastic Treatment and Application of Cast Zn-Al Eutectoid Alloy

铸造锌铝共析合金的超塑性处理及应用
来源：互联网摘选
12、

It was found that the superplasticity was also obtained directly by superplastic treatment of the cast Zn-Al eutectoid alloy.

研究指出，直接由铸造的锌铝共析合金进行超塑性处理，也可以得到超塑性。
来源：互联网摘选
13、

The Study of Superplastic Mechanism of Zn-Al Eutectoid Alloy

Zn－Al共析合金室温超塑性变形机理
来源：互联网摘选
14、

Usually, excellent Superplasticity of Zn-Al eutectoid alloy could be obtained by pre-deformation ( rolling or forging).

锌铝共析合金具有良好的超塑性，但通常需要经过预变形（轧制或锻压）来得到。
来源：互联网摘选
15、

A Study of m-c-δ( or m-k-δ) Relations of Superplastic Zn-22% Al Eutectoid Alloy

Zn-22%Al合金超塑性的m-C-δ（或m-k-δ）关系的研究
来源：互联网摘选
16、

Characteristics of internal friction and modulus associated with non-equilibrium diffusion-type phase transformation in eutectoid Al-Zn alloy

共析Al-Zn合金非平衡扩散型相变内耗和模量特征
来源：互联网摘选
17、

The eutectoid transformation temperature of five alloys is identical, being about 285C.

五种合金的共析转变温度基本相同，均在285℃左右，ZA50的共析转变热最小。
来源：互联网摘选
18、

Morphology and high resolution image of eutectoid transformation products of ti-h alloys

Ti－H合金共析转变产物的形态和结构
来源：互联网摘选
19、

Effect of high magnetic field on eutectoid point in Fe-0.76% C alloy

强磁场对Fe-0.76%C合金共析点的影响
来源：互联网摘选
20、

The dynamically mechanical properties of Zn 22% al alloys in eutectoid decomposition

Zn－22%Al合金共析转变的动态力学性质研究
来源：互联网摘选

合金的例句大全

央行新增“MLF”操作

高考英语语法填空真题34（含答案解析）

Rachel Zegler 西班牙塞哥维亚惊艳开唱，公主范儿十足！

大S流感并发肺炎离世，具俊晔放弃遗产

2025年6月六级英语作文范文3篇（带中文）

高考英语阅读理解真题92(含答案解析)