sprocket的例句大全

Tighten the internal serration screw on the exhaust sprocket.

拧紧排气链轮上的内角螺钉。

If one of the camshafts cannot be locked, loosen all the fastening screws on the affected camshaft sprocket by about one turn.

如果有一根凸轮轴无法锁定，则松开相应凸轮轴链轮上的所有紧固螺钉（旋转一圈左右）。

Remove camshaft sprocket and chain tensioner.

拆下凸轮轴链轮和链条张紧器。

If chain is not satisfactory, remove camshaft sprocket attaching bolt and remove timing chain with crankshaft and camshaft sprockets.

若正时链不令人满意，则拆下凸轮轴链轮固定螺栓，并拆下曲轴和凸轮轴链轮的正时链。

Tighten central screws on the sprocket and camshaft controller to the prescribed final torque using a torque angle wrench.

用扭力角度扳手将链轮和凸轮轴控制器上的中央螺钉拧紧至规定的最终力矩。

Development of Object-oriented CAD System for Disk Cutter of Sprocket Wheel

面向对象的盘形链轮铣刀CAD系统的开发

A Crankshaft Fluctuation Sensor ( CKF) is located near the bottom of the timing cover where it generates a signal as the crankshaft timing chain sprocket rotates past it.

曲轴位置传感器安装在定时器壳底部附近，产生一个曲轴定时链轮齿通过的信号。

The sprocket gear and the rotary plate are respectively fixed on both ends of the connecting sleeve.

链轮、连接套和旋转板的中心孔依次安装于轴上。

The main products are sprocket for motorcycle ( vehicle ) and crank-shaft for general machinery.

目前生产销售的两大类产品为传动 链轮 和通用汽油机曲轴.

In this paper, a new type tooth profile of sprocket has been given from the study of designing the bobber's axial section.

本文首先从设计滚刀的轴向截形入手，提出了链轮的新齿形；

The trunnion sprocket has come off the pinion, but do not worry-we'll soon but that right.

耳轴链齿脱离齿轮, 不过不要紧 —— 我们马上可以修好.

Put on chain between crankshaft drive sprocket and intermediate shaft drive sprocket.

安装曲轴传动链轮和中间轴传动链轮之间的链条。

A drive system for an internal combustion engine including an endless chain connecting a drive sprocket on a crankshaft to a driven sprocket on a camshaft.

一种用于内燃机的驱动系统，包括将曲轴上的主动链轮连接到凸轮轴上的从动链轮的一条环链。

Comparative study show that the drive system using the nonstandard sprocket is improved in many ways such as chain tension, contact force and friction force between chain and transmission components, tension force provided by tensioner, angular velocity of camshaft sprocket.

通过对比研究，采用非标准链轮的传动系统，其链条的张力、链条与传动部件之间的接触力和摩擦力以及张紧器的张紧力都有明显的改善。